preview-blocker.popup

Questions

1 2 3 4 5			Recent Activity

I can not connect the J2 Motor to the robot Daniel Alivov Question	0	0	18h ago

There are two STL files for print one piece. I have a 300 mm printing bed. Can I print these pieces in one shoot? Where is the STL file? matiastoledano Question	2	0	1d ago

Circle jerks Peter Cullen Question	1	0	7d ago

AR3 Robot Abbreviation Daniel Alivov Question	1	0	Feb 21

AMT102-V encoders. Been looking for months, everybody appears to be out of stock. DigiKey.ca has over 1000 in stock as of today 02/11/2021 johnan_2000 Question	0	0	Feb 11

CZH Teensy DIN rail mount johnan_2000 Discussion	2	0	Feb 11

Size and Dimensions of Hardware Kit hamzakhan76 Question	4	0	Feb 7

J6 calibration withou touchin the limit switch Daniel Tejeda Discussion	3	0	Feb 6

AMT-V102 encoder issues jasonzzpro Question	2	0	Feb 6

Robo DK post processor available/tested? noahj8675 Question	2	0	Feb 5

Adding Limit Switch in Travel Track Kstan Simit Discussion	4	0	Feb 3

I strictly followed the manual and checked the wiring many times, but I don’t know why this prompt appears. jasonzzpro Question	18	0	Feb 3

Awg Wires on pages 76, 77 Daniel Alivov Discussion	1	0	Jan 31

How can I increase the payload capacity? Dan Question	2	1	Jan 30

Difference Between AR2 and AR3 Print Files? Making Stuff Question	1	0	Jan 28

Understanding of kinematics tc ratius Question	2	0	Jan 27

In the Ardunio Code, Why have you used servo library to control stepper motors instead of stepper library? moh.nabil Question	3	0	Jan 27

How to calculate J1,2,3,4,5,6 step lim in the calibration setup ? moh.nabil Question	0	0	Jan 26

Thread pitch of screws and bolts in hardware kit hamzakhan76 Question	4	0	Jan 25

Travel Rails move very short distance Kstan Simit Question	6	0	Jan 25

1 2 3 4 5

ANNIN ROBOTICS

Questions

I can not connect the J2 Motor to the robot

There are two STL files for print one piece. I have a 300 mm printing bed. Can I print these pieces in one shoot? Where is the STL file?

Circle jerks

AR3 Robot Abbreviation

AMT102-V encoders. Been looking for months, everybody appears to be out of stock. DigiKey.ca has over 1000 in stock as of today 02/11/2021

CZH Teensy DIN rail mount

Size and Dimensions of Hardware Kit

J6 calibration withou touchin the limit switch

AMT-V102 encoder issues

Robo DK post processor available/tested?

Adding Limit Switch in Travel Track

I strictly followed the manual and checked the wiring many times, but I don’t know why this prompt appears.

Awg Wires on pages 76, 77

How can I increase the payload capacity?

Difference Between AR2 and AR3 Print Files?

Understanding of kinematics

In the Ardunio Code, Why have you used servo library to control stepper motors instead of stepper library?

How to calculate J1,2,3,4,5,6 step lim in the calibration setup ?

Thread pitch of screws and bolts in hardware kit

Travel Rails move very short distance