Hi,
Im trying setup travel railes using nema 17 with 1000mm long ball screw shaft. I'm tested jog the track and it move. However it move very-very short distance. I'm check through user manual and forum and there is no any reference can explain how it work. Chris, you have any commend or instruction for make travel track move as expected?
To make things clear, i explain how i work: 1. Set track length (in my case, 1000mm)
2. set track step limit (you need trial and error, multiply 10100xn) so that you when you jog track physically it move distance as you expected
3. press save calibration data
4. try jog 100mm
5. and measure it
If you can't get accurate result, repeat from step 1 (I don't know the reason, but both 1 and 2 you need to play till it look nice).