top of page
Forum Posts
Víctor Manuel Castañares Martín
Apr 19, 2019
In Questions
I'm going to start printing the AR2, and I just tested and compared the Nominal Size and Resized pieces, and I find that the Nominal Size pieces are exported with worse quality, and it shows a lot in the print that they are low poly. In the photo, on the right the J1 Spindle Nominal Sized and on the left the J1 Spindle Resized. Is this the case or is there an error? Regards
0
1
107
Víctor Manuel Castañares Martín
Apr 13, 2019
In General Discussion
Is there any way to get the 60t timing hub of J1 in Europe? I'm from Spain, and if I ask for it on the web or on amazon.com they charge me $ 70 for shipping costs ...
0
5
364
Víctor Manuel Castañares Martín
Jan 25, 2019
In Questions
Hi. I am collecting the pieces to assemble the ar2 and the being from Spain, because asking for things from the United States is very complicated due to the issue of customs costs. That's why I'm looking for bearings in Spain. The bearing of J4 and J6, with a shaft diameter of 1 "and outside of 1-9 / 16" is impossible for me to get here. The one I found is the AXK2542, but the outer diameter is 42mm, and the one used in the manual, 1-9 / 16 " outside in mm are 39.7mm, could the AXK 2542 be mounted on the unmodified pieces?
0
1
104
Víctor Manuel Castañares Martín
Dec 27, 2018
In Questions
Hi, I'm considering mounting the AR2, and I've seen that 5 DM542T drivers are used, from 1.0 to 4.2 A and a DM320T driver. Seeing the consumption of the engines, could not you use 5 DM320T drivers and a DM542T driver?
0
3
284
Víctor Manuel Castañares Martín
More actions
bottom of page