Hi, I'm working through the soldering for the electronics enclosure and wiring harness and wanted to make sure I'm doing things correctly. In the electronics enclosure the plug is wired Green top left, black top right. But the instructions for the wiring harness have black top left, Green top right.. is this correct? I've pasted photos below of what I'm talking about

I noticed what appears to be a typo in the electrical enclosure guide: AC power from the power supply runs up to the e stop button, and go back to terminal block number 2 where it can be distributed out to the stepper motor boards. however the guide lists the return connection is going to terminal block 7, which it should be noted is the AC neutral input from the wall *into* the DC power supply (so if I'm reading this correctly, DC voltage out is looping back into the AC input). I'm assuming this is just a typo and where it says terminal block 7 it means terminal block 2 (picture included below for reference

I'm going to post photos/videos of my AR2 build in this thread. Thanks for making this project available to the open source community!