top of page
ANNIN
ROBOTICS
HOME
FAQ
TUTORIALS
DOWNLOADS
THIRD-PARTY SOFTWARE
ROBOT KITS
FORUM
BLOG
CONTACT
More
Use tab to navigate through the menu items.
Forum Comments
Software / Motor / limit switch issues
In Questions
Anon Y. Moose
Sep 10, 2019
The previous configuration, with ribbon wires connected to headers. This was producing the odd motor behaviour described above.
0
0
Software / Motor / limit switch issues
In Questions
Anon Y. Moose
Sep 10, 2019
I'm using the screw terminal shield. I have re-confirmed that I was plugging into the correct pins. After some further fiddling, I figured out that when the ribbon cable plugs into the screw terminals instead of the black headers, all motors work. Still no luck with the limit switches however. I can confirm that when i depress each switch I read 4.7 volts with my meter. Is there something wrong with my shield? Some solder bridge somewhere perhaps? I will try to connect directly to the arduino tomorrow and report back. This configuration seems to work. All ribbon cables are connected to the screw terminals.
0
0
Anon Y. Moose
0
Followers
0
Following
More actions
Profile
Forum Posts
Forum Comments
bottom of page