top of page
Search
Writer's pictureChris Annin

Issue with MK2 base enclosure print file.

Hello, I'm sending out this message to let everyone know about an issue that was brought to my attention. There is a height issue with the J1 base enclosure for the AR4-MK2. I have modified the base enclosure to reflect the differences and fix the issue. I have updated the models on the downloads page. I apologize for this issue and I am very sorry if anyone has to re-print this part.

382 views0 comments

Recent Posts

See All

Software version 5.0

Hey everyone - I just posted a beta version of software version 5.0. In this latest version I have updated the kinematics. The new...

J3 belt tension

I wanted to send out a note to everyone to make sure you get the J3 belt tensioned properly. It does need to be fairly tight and cannot...

Software Version 4.3.1

There were some bugs on the vision tab with the snap and find drop down selection. I have replaced 4.3 with 4.3.1 on the downloads page....

Comentarios


bottom of page