top of page
Search

Correction in AR4 manual

Writer's picture: Chris AnninChris Annin

I just wanted to let everyone know that I made a correction in the AR4 manual, On page 221 I had used different brand of keystone jack that had the terminals in a different order than the keystone jacks that are being sent with the kits. With the wire colors landed on the specified terminal number the wiring is correct - the picture on 221 just showed the wire colors in different locations.

386 views0 comments

Recent Posts

See All

Software version 5.0

Hey everyone - I just posted a beta version of software version 5.0. In this latest version I have updated the kinematics. The new...

J3 belt tension

I wanted to send out a note to everyone to make sure you get the J3 belt tensioned properly. It does need to be fairly tight and cannot...

Software Version 4.3.1

There were some bugs on the vision tab with the snap and find drop down selection. I have replaced 4.3 with 4.3.1 on the downloads page....

Comments


bottom of page