Hallo what is the payload of the fully 3d printed version?
Question
Why you're using Chain Sprocket transmission technique instead of timing belt and pulley in J3? Any specific reason.
Search
New Posts
- QuestionQuestion 1: Can I teach AC3 by directly moving the joints with my hands? Question 2: Can AC3 save the program to the Teensy 3.5 SD to work offline?
I have tested it at 25oz. But have not pushed it further to it’s break point.
I think I read that you made the printed version in ABS. I'm thinking of doing it in PETG or in POM, which according to the POM is more resistant than ABS and suffers less wear. Perhaps with this material you can reach a payload somewhat lower than with aluminum, but more than 700gr. what do you think about that?